Universal cable clutch perch, sold with its aftermarket clutch lever. Adaptation guaranteed on all handlebars with an outer diameter of 22mm. 

Front LED headlight. Round adaptable model. Measures : Diameter : 7 inch (17,78 cm) Profondeur : 3,74 inch (9,5 cm) LED bulbs included in the font light, 3 pins connector similar to H4 ones that can be found on nearly all round headlights equipped naked motorbikes.

Pair of universal  LED  turn signals in plastic, with 17 LED and an orange light.

Pair of universal  LED  turn signals in plastic with orange lighting and a blinking indicator on the rear of the turn signals, towards the pilot (blinking on both sides).

Pair of universal LED turn signals in aluminum. E8 E-marked model, with 9 LED and an orange light.

Pair of universal LED turn signals in aluminum. Number of LED on each indicator : 15 Length (out of screw thread) : 36 mm Width / Diameter : 28 mm Screw diameter : 8 mm Wires length : 440 mm NOTE :  Before ordering, just make sure...

Pair of universal  LED  turn signals in aluminum.  E8 E-marked  model, with  an orange light. All the universal turn signals models we propose are visible on the last photo!

Pair of universal  LED  turn signals in plastic with 8 LEDs and an orange light.

Pair of universal  LED  turn signals in plastic.  E8 E-marked  model, with 15 LED and an orange light. Design with a center hole. For installation on MT07 / FZ07, you must install and reverse a  turn signal shutter  so the nut can be screwed on the turn signal's rod. 

Pair of universal  LED  turn signals in aluminum and an orange lighting.  Number of LED on each turn signal : 17 Length (out of screw thread) : 86 mm Width : 38 mm Screw diameter : 8 mm Wires length : 210 mm

Complete kit including : an adaptable aluminum license plate holder + a small tail light (position light / brake light / license plate light).   Adaptable model, check measurements on the last picture to make sure it will fit your needs or project.

Pair of anodised aluminum fork pre load adjusters. Available diameters : 14 mm , 17 mm , 19 mm , 22 mm

Universal booster net, for your helmet or lugguages. Measures : 40 x 40 cm

Universal mounting bracket in steel for round headlights. This model will perfectly fit and adjust without any modification on all forks with a diameter between 33 mm to 43 mm. Sold by pair.

Pair of universal rubber and anodised aluminum handlebar grips with an internal diameter of  22 mm  on the left side (clutch) and  24 mm  on the right side (throttle).   Measures : Length: 120 mm (+ 13 mm with end caps) Depth:...

Aftermarket rear brake fluid reservoir kit including the plastic reservoir + the anodized aluminum cap. Universal model. To avoid mistakes, we invite you to check the type of fastening of your original reservoir before ordering. Height: About 45mm Width: ...

Pair of anodized aluminum bar end plugs, available in several colors. Universal flat model, with a discreet offset.   Fits on all handlebars with an internal diameter of 14mm or 18mm (adapters provided). These handlebar caps can also be installed on handlebars with an integrated 6mm threaded spot (6 mm screw provided)....

Pair of universal LED turn signals in plastic with 5 SMD  LEDs  on the front, and 3 SMD LEDs on the rear side, both in orange.

Cable clutch perch, High End model in anodised aluminum. Universal for all the motorcycles equipped with a cable clutch. Will fit on all handlebars with a 22mm outer diameter. Sold with an anodised lever, to be selected among : - A short or long clutch lever (no additive cost) - Adjustable in length and foldable in case of a fall (+10€ additive...

Relax cruise control throttle grip for right side handlebar grip. Made in plastic, it will easily install directly on your throttle grip and will allow you to relax your wrist during long journeys. Universal model, will fit on nearly all accelerator grips.