Pair of license plate LED lights. Mounted on a M5 integrated threaded screw (diameter 5 mm) for a direct and discreet installation on the license plate holder.   Sold by pair only.

Mounting bracket and adaptor for rearview mirrors, universal model for all handlebars with a 22mm external diameter. Available with 8 mm or 10 mm screw thread (M8 or M10), in normal / classic thread (not inverted). Sold per unit. ...

Screw and cage nut in anodised aluminum. Sold per unit. Various colors available.

Universal aluminium license plate holder, adjustable and foldable.

Universal cable clutch perch, sold with its aftermarket clutch lever. Adaptation guaranteed on all handlebars with an outer diameter of 22mm. 

Turn signals spacers adapters in plastic, specific for many YAMAHA and KAWASAKI. These adapters can also adapt on other models.   Will fit on all KAWASAKI models produced since 1990. Will also fit for YAMAHA produced before 2002. For example  R1 2000 - 2002 ; Fazer 1000 2001 - 2005 etc   In case of doubt, your OEM turn signals must be similar to those...

Pair of universal  LED  turn signals in plastic, with 17 LED and an orange light.

Pair of universal  LED  turn signals in plastic with orange lighting and a blinking indicator on the rear of the turn signals, towards the pilot (blinking on both sides).

Pair of universal LED turn signals in aluminum. E8 E-marked model, with 9 LED and an orange light.

Pair of universal  LED  turn signals in aluminum.  E8 E-marked  model, with  an orange light. All the universal turn signals models we propose are visible on the last photo!

Pair of universal  LED  turn signals in plastic with 8 LEDs and an orange light.

Pair of universal  LED  turn signals in plastic.  E8 E-marked  model, with 15 LED and an orange light. Design with a center hole. For installation on MT07 / FZ07, you must install and reverse a  turn signal shutter  so the nut can be screwed on the turn signal's rod. 

Complete kit including : an adaptable aluminum license plate holder + a small tail light (position light / brake light / license plate light).   Adaptable model, check measurements on the last picture to make sure it will fit your needs or project.

Pair of anodised aluminum fork pre load adjusters. Available diameters : 14 mm , 17 mm , 19 mm , 22 mm

Universal booster net, for your helmet or lugguages. Measures : 40 x 40 cm

Pair of riser adjustments for tapered handlebars with a 28mm external diameter at the center. Available in different colours. Anodized machined aluminum risers with a 6-months warranty on anodizing. Total height : 50 mm Mounting bolt diameter : 10 mm

Flat handlebar in anodised machined aluminum. Universal model.    Outer diameter at the handlebar’s end: 22,2 mm Outer diameter in the center of the handlebar: 28,6mm (often indicated as 28 mm) Inside diameter: 14 mm, not threaded Weight : 630 gr    <p...

Pair of universal handguards, various colours available. Aluminum base with an ultra-hard plastic coating for an optimal shock-resistance.  Fit on all handlebars with an external diameter of 22 mm or 28 mm and an internal diameter of 14 mm, 18 mm or threaded for M8 screws (8 mm diameter...

Pair of universal rubber and anodised aluminum handlebar grips with an internal diameter of  22 mm  on the left side (clutch) and  24 mm  on the right side (throttle).   Measures : Length: 120 mm (+ 13 mm with end caps) Depth:...

Aftermarket rear brake fluid reservoir kit including the plastic reservoir + the anodized aluminum cap. Universal model. To avoid mistakes, we invite you to check the type of fastening of your original reservoir before ordering. Height: About 45mm Width: ...